Simulation experiments with cometary analogous material
by Kochan, H. W.; Huebner, W. F.; Sears, D. W. G.
Comet simulation experiments are discussed, in the context of physical models and the results in cometary physics, gathered especially from the GIOTTO space mission to comet P'Halley. The "status of the today knowledge" about comets, the experiments could start from, is briefly reviewed. The setup of the KOSI (German = Kometen Simulation) - experiments and the techniques to produce cometary analogous material, on the basis of that knowledge are described in general, as for the different KOSI experiments. The limitations of the simulation of physical processes at the surface of real comets in an earth-bound laboratory are discussed, and the possibilities to receive common insights in cometary physics are shown. Methods and procedures are described, and the major results reviewed. As with attempting to reproduce any natural phenomenon in the laboratory, there are short-comings to these experiments, but there are possibly major new insights to be gained. Physical laws only have the same consequences under same experimental or environmental conditions. A number of small-scale comet simulation experiments have been performed, since the early 60ties in many laboratories, but the largest and most ambitious series of comet simulation experiments to date were performed between 1987 and 1993 using the German space agency's (DLR) space hardware testing facilities in Cologne. These experiments were triggered by the scientific community after the comet P'Halley's recurrence in 1986 and the many data gathered by the space missions in this year. Simulation experiments have proved valuable in developing methods for making cometary analogues, and for exploring specific properties of such materials in detail. These experiments provided new insights into the morphology and physical behavior of aggregates formed out of silicate-/water-ice -grains likely to exist in comets. The formation of a dust mantle on the surface, and a system of ice layers below the mantle from the different admired materials, have been detected after the insolation of the artificial comet. The mechanisms for heat transfer between the comet's surface and its interior, compositional, structural, and isotopic changes that occur near the comet's surface, were described by modeling in accordance with the experimental results. The mechanisms of the ejection of dust and ice grains from the surface, and the importance of gas-drag in propelling grains were investigated by close-up video cameras.
- Journal
- Earth Moon and Planets
- Volume
- 80
- Issue
- 1-3
- Year
- 1998
- Start Page
- 369-411
- URL
- https://dx.doi.org/10.1023/a:1006342602452
- ISBN/ISSN
- 1573-0794; 0167-9295
- DOI
- 10.1023/a:1006342602452