3D Printed Microsampling Probe for Neuroscience

by Pysz, P. M.; Hoskins, J. K.; Zou, M.; Stenken, J. A.

A 3D-printed microsampling prototype probe that is 225 mu m in height and 250 mu m in width with a microporous membrane for neuroscience sampling applications has been fabricated. This prototype microsampling probe was designed using the dimensions of standard microdialysis sampling probes as a guide for size as well as needed fluid connections. The 3D printed microsampling probe was made using two separately printed parts. The use of two-photon polymerization (2PP) stereolithography (SLA), due to its extraordinary printing resolution was necessary to print the needle section of the microsampling probe. A 4 mm-long needle section containing an array of 6128 x 5 mu m pores was printed using the 2PP technique, while a customized tubing adapter was printed with a lower-resolution masked SLA printer to reduce overall printing time. Peripheral devices essential to assemble the functional device were custom 3D printed to fit both the tubing adapter and the needle section. Two microsampling probes were successfully fabricated and characterized for solute relative recovery using push-pull microperfusion. A pull flow rate higher than inlet flow rate is required for analyte recovery with the current microporous membrane design. Repeatable solute extraction using caffeine and blue dye #1 was achieved with both microsampling probes at different pull flow rates. This microsampling prototype device serves as a development platform for future devices that may incorporate multimodal sensor capabilities or additional functions (e.g., optogenetics and/or electrophysiological monitoring).

Journal
IEEE Sensors Letters
Volume
8
Issue
5
Year
2024
URL
https://dx.doi.org/10.1109/lsens.2024.3393488
ISBN/ISSN
2475-1472
DOI
10.1109/lsens.2024.3393488